Canon EOS 40D - Manual (Page 141)

141
wPrinting
You can crop the image and print only
the trimmed portion as if the image was
recomposed. Do the trimming right
before printing. If you set the trimming
and then set the print settings, you may
have to set the trimming again.
1
On the print setting screen, select [Trimming].
2
Set the trimming frame size, position, and proportion.
The image area within the trimming frame will be printed. The shape
of the trimming frame can be changed with [Paper settings].
Changing the trimming frame size
When you press the or button, the size of the
trimming frame will change. The smaller the trimming frame, the
larger the image magnification will be for the printing.
Moving the trimming frame
Use <9> to move the frame over the image vertically or
horizontally. Move the trimming frame until it shows the desired
image area or composition.
Rotating the frame
Each time you press the button, the trimming frame will
toggle between the vertical and horizontal orientations. This enables
you to create a vertical-oriented print from a horizontal image.
Adjusting the rotation angle
By turning the <5> dial, you can adjust the angle of the image
rotation by ±10 degrees in 0.5-degree increments. After rotation,
<
> will change to blue.
3
Press <0> to exit the trimming.
X The print setting screen will reappear.
You can check the trimmed image area on the upper left of the
print setting screen.
Trimming the Image