HP 15c - Manual (Page 68)

68 Section 6: Programming Basics
Keystrokes Display
2
002- 2
* 003- 20
9
004- 9
Given h in the X-register,
lines 002 to 008 calculate
. 005- 48
8
006- 8
9.8
2h
.
÷ 007- 10
¤ 008- 11
Program End. There are three possible endings for a program:
 | n (return) will end a program, return to line 000, and halt.
 ¦ will stop a program without moving to line 000.

The end of program memory contains an automatic n.
Keystrokes Display
|n 009- 43 32 Optional if this is the last
program in memory.
Intermediate Program Stops
Use ´ © (pause) as a program instruction to momentarily stop a
program and display an intermediate result. (Use more than one © for a
longer pause.)
Use a ¦ (run/stop) instruction to stop the program indefinitely. The
program will remain positioned at that line. You can resume program
execution (from that line) by pressing ¦ during Run mode, that is, from
the keyboard.
Running a Program
Run Mode. Switch back to Run mode when you are done programming:
| ¥. Program execution must take place in Run mode.