Change the fax speed, Problems sending faxes – HP laserjet m1212nf User Manual
Page 162
trying to send a fax overseas or receive one from overseas, or if you are using a satellite telephone
connection.
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Fax setup menu, and then press the
OK
button.
3.
Use the arrow buttons to select the All faxes menu, and then press the
OK
button.
4.
Use the arrow buttons to select the Error correction menu, and then press the
OK
button.
5.
Use the arrow buttons to select the On or Off option, and then press the
OK
button to save the
selection.
Change the fax speed
The fax-speed setting is the modem protocol that the product uses to send faxes. It is the worldwide
standard for full-duplex modems that send and receive data across telephone lines at up to 33,600 bits
per second (bps). The factory-set default for the fax-speed setting is Fast(V.34). In some countries/
regions, the factory-set default may be different to optimize transmission.
You should change the setting only if you are having trouble sending a fax to or receiving a fax from a
particular device. Decreasing the fax speed might be useful when you are trying to send a fax
overseas, or receive one from overseas, or if you are using a satellite telephone connection.
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Fax setup menu, and then press the
OK
button.
3.
Use the arrow buttons to select the All faxes menu, and then press the
OK
button.
4.
Use the arrow buttons to select the Fax Speed menu, and then press the
OK
button.
5.
Use the arrow buttons to select a speed setting, and then press the
OK
button.
Problems sending faxes
The document stops feeding in the middle of faxing.
Cause
Solution
The maximum length of a page that you can load is 355 mm
(14 inches). Faxing of a longer page stops at this
measurement.
Print the document on shorter media.
If no jam exists and less than one minute has elapsed, wait a
moment before pressing the Cancel button. If a jam exists,
remove the jam. Then, resend the job.
If the item is too small, it can jam inside the document feeder. The minimum page size for the document feeder is 148 x
105 mm (5.83 x 4.13 inches).
If a jam exists, remove the jam. Then, resend the job.
148
Chapter 10 Fax (M1210 Series only)
ENWW