Set tone-dialing or pulse-dialing, Set autoredial and the time between redials – HP laserjet m1212nf User Manual
Page 131
The factory-set default for detect dial tone is On for France and Hungary, and Off for all other
countries/regions.
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Fax setup menu, and then press the
OK
button.
3.
Use the arrow buttons to select the Fax Send setup menu, and then press the
OK
button.
4.
Use the arrow buttons to select the Detect dial tone menu, and then press the
OK
button.
5.
Use the arrow buttons to select the On or Off option, and then press the
OK
button.
Set tone-dialing or pulse-dialing
Use this procedure to set the product to tone-dialing or pulse-dialing mode. The factory-set default is
Tone. Do not change this setting unless you know that the telephone line cannot use tone dialing.
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Fax setup menu, and then press the
OK
button.
3.
Use the arrow buttons to select the Fax Send setup menu, and then press the
OK
button.
4.
Use the arrow buttons to select the Dialing Mode menu, and then press the
OK
button.
5.
Use the arrow buttons to select the Tone or Pulse option, and then press the
OK
button to save
the selection.
NOTE:
The pulse-dialing option is not available in all countries/regions.
Set autoredial and the time between redials
If the product was unable to send a fax because the receiving fax machine did not answer or was busy,
the product attempts to redial based on the redial-on-busy, redial-on-no-answer, and redial-on-
communication-error options. Use the procedures in this section to turn these options on or off.
Set the redial-on-busy option
If this option is turned on, the product redials automatically if it receives a busy signal. The factory-set
default for the redial-on-busy option is On.
1.
On the control panel, press the Setup button.
2.
Use the arrow buttons to select the Fax setup menu, and then press the
OK
button.
3.
Use the arrow buttons to select the Fax Send setup menu, and then press the
OK
button.
4.
Use the arrow buttons to select the Redial if busy menu, and then press the
OK
button.
5.
Use the arrow buttons to select the On or Off option, and then press the
OK
button.
ENWW
Set fax settings
117