I/o panel, Removing the i/o panel, Replacing the i/o panel – Dell OptiPlex GX620 User Manual
Page 132
Back to Contents Page
Dell™ OptiPlex™ GX620
User's Guide
I/O Panel
Removing the I/O Panel
1.
Follow the procedures in "
Before You Begin
."
2.
Remove the cable from the I/O panel by pulling on the pull-loop.
3.
Remove the screw that secures the I/O panel to the desktop computer.
4.
Gently rotate and slide the I/O panel away from the computer.
Replacing the I/O Panel
1.
To replace the I/O panel, follow the removal procedures in the reverse order.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTE:
Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing the new I/O panel.
NOTICE:
When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to the cable connectors and the
cable routing clips.
1 securing screw
2 I/O panel
3 I/O cable connector
4 I/O connector pull loop
NOTE:
Use the guides on the I/O panel bracket to help position the I/O panel in place and use the notch on the I/O panel bracket to help seat the card.