Yealink W52P - Manual (Page 16)

User Guide for the W52P IP DECT Phone
4
2. Connect the supplied Ethernet cable between the Internet port on the base station
and the Internet port in your network or the switch/hub device port.
Power over Ethernet
Using a regular Ethernet cable, the base station can be powered from a PoE-compliant
(IEEE 802.3af) switch or hub.
To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the base station and an
available port on the in-line power switch/hub.
Note
To insert batteries into the handset:
1. Open the battery cover.
2. Insert the batteries in the correct polarity.
If in-line power is provided, you don‟t need to connect the AC adapter. Make sure
switch/hub are PoE compliant.
Important! Do not unplug or remove the power and network to the base station while it is
updating firmware and configurations.