Bio-Rad Econo Gradient Pump Kits - Manual (Page 18)

5.0 SYSTEM OPERATION
There are four modes of system operation:
• Remote
• Setup
• Manual
• Program, including running the system
5.1 REMOTE MODE
The Econo Gradient Pump can be connected to the BioLogic
Duo-Flow Workstation running software version 3.0 or later with an
Instrument bus cable (System cables 17, 18, 19, or 21). When the
BioLogic assumes control of the Econo Gradient Pump, the Econo
Gradient Pump is automatically set to Remote Mode. In Remote
Mode, the Econo Gradient Pump keys provide limited control,
allowing only basic observation of Econo Gradient Pump operating
parameters.
5.2 SETUP MODE
Each of the pump’s features can be customized in Setup mode.
While the pump is stopped, plug in the desired valves (i.e., Gradient
Mixer, SV-3 Diverter valve, or Splitter valve) into the connectors on
back. (Note, these valves must be plugged in before any run requiring
them is started.) Then press the Mode key until the Setup LED is
illuminated. Each of the Setup windows is discussed on the following
pages.
Note: When a selection is made, it will be displayed in capital
letters.
System Operation
14
4006161B.qxd 8/14/2003 8:09 AM Page 14