Bio-Rad Gel Doc™ XR+ System - Manual (Page 28)

28
4.4.2 ChemiDoc
™
XRS System Cable Configuration
Connecting the cabling harnesses.
1. Locate the FireWire cable. Connect one end of the FireWire cable connector to the FireWire
connector on the camera.
2. Connect the other end to the FireWire connector on the PC/Mac.
3. The camera power supply cable should be plugged into the CCD camera power connector.
4. Connect one end of the USB cable to the connector labeled ‘TO PC’ on the hood, and the other
end to the USB port on the PC.
5. Connect the MZL cable connector the extension cable. Connect the other end of the extension
cable to the connector labeled LENS on the rear panel of the universal hood.
The following table describes the cable connectors and their designations.
Label Instrument/Connection
6-pin FireWire cable/connector FireWire connector from camera to PC
Camera power supply cord/power supply Camera/PWR connector
10 ft USB cable From Hood to PC
MZL (motorized zoom lens) cable LENS Din connector to extension cable din connector
MZL extension cable Extension cable din connector to Hood connector
Power cable Connects the Hood to the power outlet on the wall
Power cable
from power
supply
MZL cables
USB cable
FireWire cable