Baseline Systems BaseManager 2.0 - Manual (Page 23)

to use for the pause condition. In the Pause Time field, type the number of minutes you want the system
to pause when this condition is activated.
Zone Settings
Expand the Zone section, and then perform any of the following tasks:
• To change the run time for a zone, type a new number in the Run Time field for that zone.
• To change the seasonal adjustment percentage for all the zones in the program, type a number in the field
in the header row.
• To add a zone, click the Add Zone button. Click the drop-down arrow in the box in the Zone column. From
the list, select the zone that you want to add. Click the Save button on the end of the program row. After
the screen refreshes, click the Edit Program button on the program row and complete the settings for the
new zone.
Point of Connection Assignments
Expand the Point of Connection Assignments section, and then perform any of the following tasks:
• To assign a water source, click the Add Water Source button, and then select the water source that you
want to assign to this program.
• To assign a master valve, click the Add Master Valve button. Click the arrow in the master valve list, and
then select the master valve that you want to assign to this program.
8. Click the Save button on the end of the program row.
Working with the BaseManager Map
One of the most convenient features of BaseManager is the map interface. As a company admin, you can map the
layout of your sites with icons that represent your controllers and their associated devices. After you have
completed the map configuration, you and your users can perform the following tasks from the map interface:
• Check the status of any controller, device, or zone
• Find the location of your controllers, devices, and zones
• Start/stop a zone
• Test devices and zones
• Display a graph for devices and zones
• Set a rain delay
• Zoom in/out of the map view
• Switch between a street map view, satellite view, and terrain view
In BaseManager, in the list under the All tab on the left side of the map, click the site that you want to update the
map for. The controllers for that site display below the site name.
Click the controller that you want to update the map for. A blue arrow displays next to the name of the controller
that you clicked. It may take a few moments for the map to load.
Selecting a Site & Controller
1. In the upper-left corner of the main BaseManager interface, click the All tab. Your sites display under that tab.