Baseline Systems BaseStation 3200 - Manual (Page 16)

C h a p t e r 1 – G e t t i n g S t a r t e d
Page 14
Baseline 3200
1
Getting Started
Section Contents

Installing the BaseStation 3200 .......................................................................................... 14

Installing Standard Accessories .......................................................................................... 17

Conventional Irrigation Wiring Installation......................................................................... 18

Two-wire Installation .......................................................................................................... 20

Searching for and Assigning Valves .................................................................................... 26

BL-Commander ................................................................................................................... 34
Installing the BaseStation 3200
This section covers the basic installation of the various 3200 controllers.
C-series Wall Mount Cabinets
The C-series Wall Mount cabinet is designed for outdoor or indoor wall or pole mounting. The
cabinet features four screw or bolt mounting holes on tabs above and below the controller
chassis as shown below:
Mounting Holes
The screw holes are approximately 1/4” x 1/3”, and are located
3” apart.
For exterior and especially for pole or post mounted
applications, care should be taken to avoid direct spray from
sprinkler heads or other water sources.
For detailed dimensions and
installation drawings, please visit
the documentation library on the
Baseline web site.
Connecting power & ground
All C-series Wall Mount 3200 controller ship with a conduit ready ½”
male exposed thread connection point as shown in the diagram:
AC power connections should be made in an approved electrical
connection junction box, and in accordance with all local
electrical codes.
Wire nuts for AC power connections are provided.
110VAC Conduit connection
(240VAC for –INT units)