ADS Environmental Services Model 4000 530017 A0 - Manual (Page 90)

5-4 ADS Model 4000 Manual
2. Loosen bolts and remove the monitor lid with chassis from the
aluminum canister.
3. Remove the cables ties securing the battery pack, and unscrew
the rubber stops holding the battery pack in place.
4. Disconnect the orange connector (attached to the cable running
from the battery pack) from the processor board (P6).
5. Remove the battery pack from the chassis.
6. Place the new battery pack into the chassis, and replace the
rubber stops. Press the stops against the battery pack to ensure
proper installation.
7. Connect the orange connector from the battery pack to the
processor board (P6 connector).
Replacing the battery pack in the monitor
Note: A green light on the processor board will flicker on
and off upon connection.
8. Have an analyst call the monitor or connect to the monitor on
site to verify communication.
9. Carefully replace the monitor chassis into the enclosure, and
torque down the bolts securing the chassis to the enclosure to
35 inch pounds (+/- 5 inch pounds).