Bleeding opener lift hydraulics – Great Plains 3S-3000HDF Predelivery Manual User Manual
Page 30
28 3S-3000HD
195-068Q
12/09/2009
Bleeding Opener Lift Hydraulics
Review warnings, bleeding notes and system infor-
mation on page 26.
2.
Make sure opener frames are locked up in ROAD
position. See “Opener Lock Up” in Operator’s Man-
ual.
3.
Turn knob on both pressure-control valves com-
pletely counterclockwise, then turn valves clockwise
far enough to build up 1000 psi (about three turns).
4.
Turn knob on bypass valve completely clockwise for
no oil flow.
5.
Loosen six hose-end JIC fittings at three locations
on the opener-lift circuit:
• both JIC fittings on the two
3
⁄
8
in opener lift hoses
feeding the center opener lift cylinders,
• the JIC fittings on the two
3
⁄
8
in opener lift hoses
feeding the center opener lift cylinders, and;
• the end where these center two hoses tee at the
middle of the center box frame.
6.
Slowly supply oil to top side of pressure-control
valves until oil begins to appear at a loosened hose
fitting. As oil begins to appear at a fitting, tighten
that fitting.
7.
Slowly supply oil to bottom side of pressure-control
valves until oil begins to appear at remaining loos-
ened hose fitting. As oil begins to appear at the fit-
ting, tighten fitting. Continue to supply oil to bottom
side of pressure-control valves until all openers are
raised completely.
8.
Move opener transport locks to FIELD position and
cycle openers up and down ten times. Each time
you lower openers, hold tractor remote lever until
opener circuit builds up to pressure set at control
valves.
9.
After cycling openers, return opener transport locks
to ROAD position, and lock openers up.
Figure 30
Bleeding Opener Lift Hydraulics
15644