Great Plains 3S-3000HDF Predelivery Manual - Manual (Page 23)

Assembly 21
12/09/2009 195-068Q
Open Center Conversion
If the drill was shipped with an Open Center kit, it is not
factory-installed. Install it now. An installation manual is
provided.
Point Row Option
If the Point Row Option was ordered with the drill, the
hydraulics and drill electrical lead are factory-installed.
If the customer’s primary tractor is available, install the
control module in the tractor cable and make the electri-
cal connection. Consult the Point Row installation man-
ual provided.
If the primary tractor is not available, temporarily con-
nect the control module so that openers can be oper-
ated during Setup.
Post Assembly Checklist
• Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
• Check for proper tension and alignment on all drive
chains.
• Check that all safety decals and reflectors are located
correctly and are legible. Replace if improperly
located or damaged. Refer to “Safety Decals” in the
Operator’s manual.
• Inflate tires to recommended pressures as listed on
the “Tire Inflation Chart” on page 38. Tighten wheel
bolts as specified on “Torque Values Chart” on page
39.
BASE END
, CENTER OPENERS
ROD END
CENTER OPENERS
BASE END
WING OPENERS
ROD END
WING OPENERS
P
G
R
T
P
G
R
T
3
LOWER
TO TRACTOR
RAISE
1 2
3
1
2
3
FILTER
Figure 20
Open Center Conversion
18750
Figure 21
Point-Row Connector
26469