Great Plains UT5052 Operator Manual - Manual (Page 28)

Section 1: Assembly Great Plains Mfg., Inc.
Series I UT3030-UT5052 Ultra-Till 576-026M 10/28/2004
26
Completing Setup
Install the plastic end caps into the
open ends of all the 4x3 frame tubes.
Finish plumbing the Ultra-till hydraulic
lift and gang systems from the layouts in
Hydraulics in parts manual. Cycle the
hydraulic systems to purge the cylinders of air
while checking for leaks.
You should now be ready to add the
harrow modules and the remaining gangs to
the machine. If the machine has a finishing
attachment you would install it last. See the
machine layout section 4 for proper module
dimensions and gang sizes for your unit.
The parts manual shows the harrow
module assembly with parts along with gang
parts and identification drawings.
Once the harrow modules and gangs
are installed and all of the hydraulic
procedures have been completed, you may fold
the machine to check for clearance and proper
module placement. Slowly fold the machine
while watching that hoses do not become
pinched or kinked and watch that modules
clear all obstructions.
Once the machine is folded completely,
begin to unfold slowly. Be Sure No One Is
Under The Wings When You Unfold The
Machine. Once the machine is unfolded, add
the safety decals and the product decals. Refer
to the Important Safety Information section
(page 7) for the proper placement of safety
decals.
Install the safety chain, SMV sign &
safety lights in accordance with local and state
laws. See parts manual (Frame section) for
assembly drawings and parts list.
At this point, set up of the machine is
complete and you are ready to add any
finishing attachment, rear hitches, etc… to the
machine. Be sure to consult the operating
instructions, Section 4, for the first time field
adjustments before going to the field for the
first time.
4/11/2005