Bleeding marker hydraulics, In-line filters – Great Plains 2S-2600HDF Operator Manual v1 User Manual
Page 76
72
2S-2600/F/HD/HDF
Great Plains Manufacturing, Inc.
195-440M
2014-05-16
Bleeding Marker Hydraulics
Crushing Hazard:
You may be injured if hit by a folding or unfolding marker.
Markers may fall quickly and unexpectedly if the hydraulics
fail. Never allow anyone near the drill when folding or unfold-
ing markers.
1.
Review warnings, bleeding notes and system infor-
mation on page 68.
Refer to Figure 75
2.
With markers unfolded in field position, crack
hydraulic-hose JIC fittings
at base and rod ends of
each marker cylinder.
3.
With tractor at idle speed, activate tractor hydraulic
valve forward until oil appears at a fitting. When oil
begins to seep out around a fitting, tighten that
fitting. Reverse the tractor hydraulic valve until oil
appears at opposite hose fitting. Tighten that fitting.
4.
If you have dual markers, activate tractor hydraulic
valve forward again until oil seeps out around a fitting
on the other marker cylinder. Tighten that fitting.
Reverse tractor hydraulic valve until oil seeps out
around remaining hose fitting and tighten it.
5.
Fold and unfold markers slowly to work out all air.
Note: Use caution when folding and unfolding markers
for the first time, checking for pinching and kinking
of hoses.
In-Line Filters
If the raising or lowering times of the openers slow
noticeably, check the in-line filters and clean if needed.
Refer to Figure 76
Two filters are located on one each of the down-pressure
adjustment valves. If the Point Row option is installed,
another filter is located on the third adjustment valve.
Figure 75
Bleeding Marker Hydraulics
18942
1
Figure 76
In-Line Filter Locations
22968