Great Plains 2S-2600HDF Operator Manual v1 User Manual
Operator manual, Manufacturing, inc
Manufacturing, Inc.
© Copyright 2014
Printed 2014-05-16
195-440M
EN
ORIGINAL INSTRUCTIONS
Operator Manual
2S-2600/F/HD/HDF
Two-Section 26-Foot Folding Drill
Read the operator manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit or may
depict similar models where a topic is identical.
17254
This manual is related to the following products:
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Be Familiar with Safety Decals
- Prepare for Emergencies
- Wear Protective Equipment
- Avoid High Pressure Fluids
- Use A Safety Chain
- Use Safety Lights and Devices
- Keep Riders Off Machinery
- Transport Machinery Safely
- Check for Overhead Lines
- Handle Chemicals Properly
- Shutdown and Storage
- Practice Safe Maintenance
- Tire Safety
- Safety At All Times
- Safety Decals
- Safety Reflectors and Decals
- 818-003C Slow Moving Vehicle Reflector
- 838-266C Red Reflectors
- 838-265C Amber Reflectors
- 838-267C Daytime Reflectors
- 818-557C Danger: Cannot Read English
- 818-864C Danger: Pinch/Crush Hazard
- 838-467C Danger: Possible Chemical Hazard
- 838-102C Warning: Falling Hazard
- 818-019C Warning: Negative Tongue Weight
- 818-045C Warning: Pinch/Crush Hazard
- 818-337C Warning: Excessive Speed Hazard
- 818-339C Warning: High Pressure Fluid
- 818-682C Warning: Marker Pinch Crush
- 818-861C Warning: Transport Locks
- 818-398C Caution: Tires Not A Step
- 818-751C Caution: 32 PSI Tire Pressure
- 818-752C Caution: 52 PSI Tire Pressure
- Introduction
- Preparation and Setup
- Operating Instructions
- General Description
- Pre-Start Checklist
- Raising and Lowering Openers
- Raising Drill (Transport Lift)
- Folding
- Transport
- Unfolding
- Lowering Drill (Transport Lift)
- Opener Operation
- Loading Main Seed Box
- Fertilizer Box Operation
- Marker Operation
- Lift Selector Valve Operation
- Point Row Operation
- Shaft Monitor Operation
- Electronic Acremeter
- Field Operations
- Parking
- Storage
- Adjustments
- Troubleshooting
- Maintenance and Lubrication
- Bleeding Hydraulics
- In-Line Filters
- Leveling the Drill
- Chain Maintenance
- Marker Maintenance
- Main Box Seed Meter Clean-Out
- Fertilizer Box Clean-Out
- Small Seeds Box Clean-Out
- Seed Flap Replacement
- Lubrication
- Drive Shaft Clutches
- Marker Hinge Pivots
- Opener Frame Pivots
- Gauge Wheel Opener Frame Pivots
- Wing Horizontal (Flex) Pivots
- Fertilizer Shaft Bearings
- Small Seeds Shaft Bearings
- Adjustment Link Pivots
- Felt Barrier Seals
- Seed Cup Drive Shaft Sprocket
- Wing Vertical (Fold) Pivots
- Transport Axle
- Fertilizer Jackshaft to Meter Shaft Chain
- Fertilizer Range to Jackshaft Chain
- Clutch Shaft to Fertilizer Range Chain
- Clutch to Seed (Drive Type) Jackshaft Chain
- Gauge Wheel Chain
- Seed Jackshaft to Meter Shaft Chain
- Small Seeds Drive Chains
- Gauge Wheel Bearings
- Transport Wheel Bearings
- Marker Disk Bearings
- Options
- Appendix
- Index