Great Plains 2S-2600HDF Operator Manual v1 - Manual (Page 68)

195-440M Table of Contents Index 2014-05-16
64 2S-2600/F/HD/HDF Table of Contents Index Great Plains Manufacturing, Inc.
Troubleshooting
Problem Solution
Uneven seed spacing or
uneven stand Check for plugging in seed cup.
Check if seed tubes are plugged.
Reduce ground speed.
Check that opener disks turn freely.
Use a faster drive type and close seed-cup doors to narrower position.
Check if openers have enough down pressure to penetrate soil. Increase hydraulic
down pressure on openers if necessary. See “Active Hydraulic Systems” on page 32
and “Opener Frame Down-Force” on page 51.
Check for trash or mud build-up on Seed-Lok wheels. Lock up if necessary. See
“Seed-Lok™ Seed Firmer Lock-Up” on page 59.
Check if hydraulic down pressure on openers is too high, causing gauge wheels to
loose contact with ground. Decrease hydraulic down pressure if necessary. See
“Active Hydraulic Systems” on page 32.
Opener disks not turning
freely Check for trash or mud build-up on disk scrapers. Readjust scrapers if necessary. See
“Disk Scraper Adjustments” on page 58.
Check if scrapers are adjusted too tight, restricting disk movement. Readjust scrapers
if necessary. See “Disk Scraper Adjustments” on page 58.
Check disk bearings.
Check opener frame for possible damage.
If opener disks turn freely by hand but not in field, reduce hydraulic down pressure.
See “Active Hydraulic Systems” on page 32.
Check press-wheel adjustment for seeding depth. See “Active Hydraulic Systems”
on page 32.
Actual seeding rate
is different than desired Check tire pressure. See “Tire Inflation Chart” on page 95.
Check wing gauge wheels. Proper size is 9.5Lx15 6-ply Rib Implement.
Check for build-up of seed treatment. Regularly clean off build-up.
Check seed-rate setting. See “Setting Main Box Seed Rate” on page 47 or “Small
Seeds Rate” on page 48.
Consider your seed weight. Seed-rate charts are based on average seed weights.
Excessive seed cracking Use slower drive type and open seed-cup doors to a wider position.
Acremeter doesn’t mea-
sure accurately Check tire pressure. See “Tire Inflation Chart” on page 95.
Check gauge-wheel tires. Proper size is 9.5Lx15 6-ply Rib Implement.
Check planting operation for excessive overlap or gaps between passes.
Consider soil conditions. Loose soil and slippage will cause variations in acres regis-
tered.
Check that your acremeter is for your drill. Refer to the 2S-2600 parts manual.
Uneven seeding depth See “Opener Depth (Press Wheel Height)” on page 59.
Check that drill tongue matches tractor-drawbar height. See “Hitching” on page 14.