Great Plains 2525A Operator Manual - Manual (Page 58)

54 2025A/2525A Table of Contents Index Great Plains Manufacturing, Inc.
118-999M Table of Contents Index 2013-06-04
Press Wheel Adjustment
The press wheels close the furrow which gently presses
the soil over the seed to ensure good seed-to-soil con-
tact for even emergence.
To provide consistent seed firming, the press wheels are
free to move downward from their normal operating posi-
tion. This system maintains closing/pressing action even
if the row unit arm is lifted when the disks encounter
obstructions.
There are three adjustments available on the press
wheel assembly:
Refer to Figure 60
1. Down pressure (shown at maximum)
2. Wheel stagger (shown staggered)
3. Centering (see Figure 62 on page 55)
Press Wheel Down Pressure
Handle
sets down pressure, which may need adjust-
ment for different soil types and field conditions.
• Relax the handle forward (in the direction of travel) for
decreased down pressure.
• Pull the handle back for increased down pressure.
Note: Higher press wheel down pressures reduce the
down force on the main row unit shank compo-
nents, such as the openers. High press wheel set-
tings may require an increase in overall row unit
down force. See page 38.
Press Wheel Stagger
The factory stagger setting has been found optimal for
residue flow. If your conditions appear to require even
press wheels, you might try one row before re-configur-
ing the entire planter. To change the stagger:
Refer to Figure 61
1. Raise the drill. Set stands or jacks under drill frame.
Shut off tractor and remove key.
2. Remove the bolt , nut and lock-washer for the
left press wheel .
3. Move the spacer and wheel to the forward of
the two mounting holes at .
4. Re-install the bolt, lock washer and nut. Tighten.
Higher press wheel down pressures reduce the down
force on the main row unit shank components, such as
the openers. High press wheel settings may require an
increase in overall row unit down force. See page 38.
Figure 60
Press Wheel Adjustments
25118
1
3
2
1
1
Figure 61
Press Wheel Force & Stagger
22907
1
8
7
6
5
3
4
2
4 5 6
8
7 8
2