Great Plains 1525P Operator Manual - Manual (Page 38)

1525P, 1510HDP
118-949M 8/14/2006
36
Cleaning Out Meters
NOTE: Shut off sliding seed tubes before at-
tempting to clean out seed meters.
For seed meter clean out:
1. Position tarp or buckets under the opener(s)
whose meter(s) you will be cleaning out.
Refer to Figure 37
2. Remove retaining clip and pull pin.
Refer to Figure 38
3. Pull up on meter clean out door to open.
4. When meter is empty, push meter clean out
door back to its original position to close.
NOTE: You may need to shake the clean out
door a little before closing to make sure all
seeds fall out.
Refer to Figure 39
5. Replace pin and retaining clip.
Figure 37
Meter Clean Out
22856
Retaining clip
Clean out door
Figure 38
Meter Clean Out Door
22857
Clean out door
Figure 39
Meter Clean Out Pin
22858