Great Plains 4000TM Assembly Manual - Manual (Page 30)

26 3500-4000TM Great Plains Manufacturing, Inc.
586-537Q-ENG 12/03/2013
Attach Hose Clamps and Hose Wraps
Note: Refer to hydraulic layouts in “Appendix” section of this
manual for proper lift and fold hose routing on center
and wings. Do not clamp hoses on hitch until gang hos-
es are hooked up, See “Gang Cylinder Purging” on
page 39. See “Hydraulic Connector ID” on page 47
for proper fitting installation.
Refer to Figure 20
82. When all the lift and fold hoses are hooked up and tight-
ened properly, put hose clamps on hoses as shown.
83. Install hose wraps on hoses as needed.
Note: Be sure and get hoses and light wiring harness fas-
tened properly so they do not drag. Check to be sure
there is enough slack in hinge area when folding ma-
chine the first time.
Hydraulic Hose Hookup
84. Great Plains hydraulic hoses are color coded to help you
hookup hoses to your tractor outlets. Hoses that go to
the same remote valve are marked with the same color.
Hose Handles
Refer to Figure 21
85. To distinguish hoses on the same hydraulic circuit, refer
to hose handles. The hose under an extended-cylinder
symbol feeds a cylinder base end. The hose under a
retracted-cylinder symbol feeds a cylinder rod end.
86. Once all hoses are tightened, hook hoses to tractor.
Color Hydraulic Function
Black Lift (2 hoses)
Green Fold (2 hoses)
Red Gang Adjustment (2 hoses)
Figure 20
Hose Clamp Assembly
41583
High Pressure Fluid Hazard:
Relieve pressure before disconnecting hydraulic lines. Use
paper or cardboard, NOT BODY PARTS, to check for leaks.
Wear protective gloves and safety glasses or goggles when
working with hydraulic systems. Escaping fluid under pressure
can have sufficient pressure to penetrate the skin causing seri-
ous injury. If an accident occurs, seek immediate medical
assistance from a physician familiar with this type of injury.
Only trained personnel should work on system hydraulics.
Figure 21
Hose Handles
41552