Great Plains 4000TM Assembly Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Introduction 7
12/03/2013 586-537Q-ENG
Unloading
Once everything is unloaded from “storage pod” you may
proceed with taking parts out of shipping containers.
Carefully move everything to level site and prepare to un
pack items.
Unpacking Components
Be sure you have read and understood the Important
Safety Information, starting on page 1 of this manual,
before you start unpacking components.
Centering components:
Be sure and center fork truck or chains (overhead hoist)
on components so they won’t slide and cause injury.
Carefully un-band components.
Now unload individual components one at a time using a
fork truck or overhead hoist.
Move each component out of the way so you have plenty
of room to remove the next one.
Unload Smaller Items First
Unloading the frames is a potentially dangerous opera-
tion.
Reduce risk and complication by first unloading
1. the tire wheel assemblies,
2. the smaller items
Place these components well out of the maneuvering
area needed for unloading the gang assemblies and
frames.
3. Carefully unload the frames and hitch out of shipping
rack
Unpacking Boxes
1. Carefully remove banding and lids from boxes.
2. Locate and identify all components before assem-
bling.
Assembly and Setup Assistance
To order additional copies of pre-delivery instructions or
operator’s and parts manuals, write to the following
address. Include model numbers in all correspondence.
If you do not understand any part of this manual or have
any assembly or setup questions, assistance is available.
Contact:
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
(800)255-9215