Great Plains 4000TM Assembly Manual - Manual (Page 26)

22 3500-4000TM Great Plains Manufacturing, Inc.
586-537Q-ENG 12/03/2013
4000 Hydraulic Wing Lift & Gangs
Refer to Figure 18
Note: The hydraulic hoses are fastened to correct center
frame cylinders, valves and double block tees. The
hoses will need unrolled and routed to wings. The
hose ends and fittings on cylinders will also have
color coded plastic ties to help get the hoses
hooked up correctly as it is very important to get
them hooked up correctly or hydraulic system will
not function properly. Be sure hose ends and fit-
tings are clean before assembling hoses. Be sure
196-430D orifice is installed on rod end outside
gang cylinder between cylinder port and 811-
063C elbow.
76. Attach hoses to cylinders on wings as shown, See
“4000 Hydraulic Wing Lift & Gang” on page 23.
Note: Do not over tighten hoses as this could cause
damage to valves, See “Hydraulic Connector ID”
on page 47
77. Fasten hoses to wings with bolts and clamps (pro-
vided). Attach hose wraps on hoses to prevent hoses
from dragging or getting pinched.
78. Also see Hydraulic Layouts in “Appendix Section” for
all hose routing.