Great Plains 4000TM Assembly Manual - Manual (Page 14)

10 3500-4000TM Great Plains Manufacturing, Inc.
586-537Q-ENG 12/03/2013
Wing Stops & Fold Brackets
Refer to Figure 7
14. Attach front
and rear fold brackets to center
frame plates with 3/4x 2 hex bolts , 3/4 lock wash-
ers and 3/4 nuts.
15. Install double block tees in locations shown below
and the smv post to back of rear fold bracket
with 5/16 x 5 1/2 hex bolt , 5/16 x 2 1/2 hex bolt ,
5/16 x 4 hex bolt , 5/16 lock washers and 5/16
nuts.
16. Attach center wing stops to center brace bar
plates with 5/8 x 1 1/2 hex bolts , 5/8 lock washers
and 5/8 nuts.
17. Attach the 3/4 x 4 3/8 hitch pin to tube of wing
stops .
18. Attach rear wing stop to center frame with 5/8 x 3
1/32 x 5 1/2 u-bolts , 5/8 lock washers and 5/8
nuts.
19. Bolts may be tightened to specs, See “Torque Val-
ues Chart” on page 46 and all cotter pins may be
bent.
1 2
3
4
5 2
6 7
8
9
10
11
9
12
13
U
D
F
B
L
R
10
5
1
2
8
9
3
4
Figure 7
Wing Stops & Fold Brackets 43138
3
9
4
6
7
4
12
10
11
13
10