Great Plains 3N-4020 Operator Manual - Manual (Page 38)

34 3N-4010F/3N-4010HDF/3N-4020F Table of Contents Index Great Plains Manufacturing, Inc.
196-359M Table of Contents Index 2013-10-29
Parking
Following these steps when parking the drill for periods
of less than 36 hours. For longer periods, see Storage,
the next topic.
1. Spot the drill on firm, level ground.
2. Raise the drill. Install transport locks.
3. Fold as necessary for the parking space available.
4. Securely block drill tires to prevent rolling.
Roll-Away Hazard
Always block drill tires when unhitching. There is not enough
weight on tongue to anchor drill using parking jack.
Do NOT unhitch on a steep slope.
Always unhook safety chain LAST.
Storage
Store the drill where children do not play. If possible,
store inside for longer life, or cover with tarp.
5. Unload seed boxes. See page 101.
6. Lubricate the drill at all points listed under “Lubrica-
tion” on page 114.
7. Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
8. Check all moving parts for wear or damage. Make
notes of any parts needing repair before the next
season.
9. Plug or cap seed delivery tubes to prevent pest entry.
10. Grease exposed cylinder rods to prevent rust. Be
sure to completely de-grease before next use, to pre-
vent seal damage.
11. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
Figure 34
Drill on Parking Stand
20273