10hd opener maintenance, 10hd disk spreader-scraper, 20 series opener maintenance – Great Plains 3N-4020 Operator Manual User Manual
Page 116: 20 series side gauge wheels

112
3N-4010F/3N-4010HDF/3N-4020F
Great Plains Manufacturing, Inc.
196-359M
2013-10-29
10HD Opener Maintenance
10HD Disk Spreader-Scraper
Refer to Figure 159
To perform this inspection (and replacement), it may be
necessary to remove one or both opener disk blades.
1.
With unit raised, remove bolt
holding on one or
both blades.
Note: Keep the spacer washers
on the outside of the
disk on the bolt. Do not misplace the spacers
on
the insider of the disk. They control disk-to-disk
contact.
2.
Check blade spreader
for wear. Replace spreader
assembly if the lower section
ahead of the seed
tube bracket is
1
⁄
2
in (13mm) thick or narrower.
3.
To replace, remove seed tube
, drive out roll pins
and install new spreader.
4.
When reinstalling disk blades, put spacers back on in
same order as removed.
Note: It is normal for blade spreader to have some loose-
ness in the holder and between the blades. Some
looseness is required for proper operation.
20 Series Opener Maintenance
20 Series Side Gauge Wheels
Refer to Figure 160
1.
Lift opener side wheel
off the ground. Move tire in
and out to check for end play. Check for roughness in
bearing by rotating wheel. If the bearings are rough,
inspect and replace if necessary.
2.
Check for the correct number of flat washers
and
machine washer
between the side gauge wheel
and the wheel arm
. There must be three flat
washers
and one machine washer
between the
wheel bearing and arm with the machine washer
next to the arm. There should be three flat washers
and one lock washer
on the outside of the
wheel. When installed, the wheel should turn freely
and not hit the arm at the curve. Do not add any
more washers than necessary.
3.
Disassemble side-gauge-wheel arm from unit.
Remove bushing
from sleeve
and check bush-
ing for wear. Replace bushing if necessary.
4.
When reinstalling side gauge wheels, align tab on
hex adjustment
with notch in bushing. Replace
bolt and tighten.
Figure 159
10HD Spreader/Scraper
27228
3
2
1
4
5
6
7
1
2
3
4
5
6
7
1
2
.eps
45%
Figure 160
20 Series Side Depth Wheel
20432
3
2
4
5
6
7
8
9
1
2
3
1
4
2
3
3
2
5
6
7
8