Pre-transport checklist – Great Plains 3N-4020 Operator Manual User Manual
Page 31
Great Plains Manufacturing, Inc.
Operating Instructions
27
2013-10-29
196-359M
Pre-Transport Checklist
Before transporting the drill, check and observe the fol-
lowing items.
❑ Make sure the weight of the tractor equals or exceeds
the value specified for your drill configuration.
❑ Marker Checklist Complete
Markers must be folded.
❑ Master Switches Off
Check that the Veris and point row (if any) master
switches are off while transporting.
❑ Drill Raised and Locked
Lift transport locks installed.
Wings folded and locked, with circuit lever in neutral.
❑ Tires
Check that all tires are properly inflated as listed on
“Tire Inflation Chart” on page 125.
❑ Bystanders
Check that no one is in the way before moving. Do not
allow any one to ride on the drill.
❑ Warning Lights
Always use tractor and drill warning lights when trans-
porting the drill.
❑ Clearance
Know the maximum dimensions of the tractor and drill
in transport position and follow a route that provides
adequate clearance from all obstructions, including
overhead lines.
See “Specifications and Capacities” on page 125.
❑ Stopping Distance
Allow sufficient stopping distance and reduce speed
prior to any turns or maneuvers. If the drill is trans-
ported full, allow extra stopping distance.
❑ Road Rules
Comply with all national, regional and local laws when
transporting on public roads.
❑ Watch Traffic
The drill boxes obstruct a portion of your rear view. Be
prepared for sudden maneuvers from following vehi-
cles.
Figure 26
Marker in Transport Cradle
18857