Great Plains 1007NT Operator Manual - Manual (Page 55)

Great Plains Manufacturing, Inc. Maintenance and Lubrication 51
10/06/2010 150-290M
Gearbox
The gearbox is lubricated and sealed at the factory.
Under normal conditions, it does not require mainte-
nance or lubrication.
If the gearbox has been opened for repair, repack all
gears and around shaft bearings using at least 7 oz. of
gear lube, Great Plains Part No. 788067.
Keep moisture and dirt out of gearbox. Inspect (replace if
needed) the rubber seals on gearbox drive and shifter
shafts.
Spread a small skin coat of anaerobic sealant (Loctite
525 or equivalent) to gear case mating surfaces before
bolting them back together.
14757
Use sparingly. Excess sealant may squeeze off the intended
surface and lock bearings or gears.
Upon
Repair