Great Plains 1007NT Operator Manual - Manual (Page 17)

10/06/2010 150-290M
Great Plains Manufacturing, Inc. Preparation and Setup 13
Preparation and Setup
This section helps you prepare your tractor and drill for
use.
Initial Setup
If the drill has just been delivered, or broken down for re-
shipment, these items need to be completed prior to first
field use:
• “Initial Setup” on page 72, which includes:
• “Hydraulic Setup” on page 73, and
• “Adjust Hitch Height” on page 74
You may also need to install features, options and acces-
sories that are not factory-installed, including:
• “Seed Rate Reduction Installation”
(separate manual),
• “Scraper Installation” on page 76.
Pre-Planting Setup
The balance of this section covers items that need to be
completed or checked prior to each field use of the drill.
Pre-Setup Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1.
2. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
3. Check that all grease fittings are in place and lubri-
cated. Refer to “Lubrication” on page 47.
4. Check that all safety decals and reflectors are cor-
rectly located and legible. Replace if damaged. See
“Safety Decals” on page 5.
5. Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Torque Values” on
page 59.