Great Plains 1007NT Operator Manual - Manual (Page 21)

10/06/2010 150-290M
Great Plains Manufacturing, Inc. Operating Instructions 17
Operating Instructions
This section covers general operating procedures. Expe-
rience, machine familiarity and the following information
will lead to efficient operation and good working habits.
Always operate farm machinery with safety in mind.
Pre-Start Checklist
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Check all hydraulic lines and fittings before
applying pressure. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If injured,
seek immediate medical attention from a physician familiar
with this type of injury.
1. Carefully read “Important Safety Information” on
page 1.
2. Lubricate drill as indicated under “Lubrication” on
page 47.
3. Check all tires for proper inflation. See “Tire Inflation
Chart ” on page 58.
4. Check all bolts, pins and fasteners. Torque as shown
in “Torque Values” on page 59.
5. Check drill for worn or damaged parts. Repair or
replace parts before going to the field.
6. Check hydraulic hoses, fittings and cylinders for
leaks. Repair or replace before going to the field.
7. Rotate each ground drive wheel to see that the
drives and meters are working properly and free
from foreign material.
Watch your step when walking on drill ladder and walkboard.
Falling from drill could cause severe injury or death.