ClearOne MU5066 - Manual (Page 14)

MUSICA KEYPAD AMPLIFIER MENU LIST
All specifications subject to change without notification. All rights reserved. Copyright©2007 NetStreams
Main +1 512.977.9393 / fax +1 512.977.9398 / 3600 W. Parmer Lane Suite 100, Austin, TX 78727 / www.netstreams.com
NS-0505-7121
11
Keypad Menu List
Sound:
Provide control over the sound such as:
Balance and Loudness
Balance: 15 steps from left to right, including center.
Loudness: ON/OFF
5-band graphic equalizer: 100 Hz, 300 Hz, 1 k Hz, 3 k Hz, 10 k Hz.
3D Sound mode: ON/OFF (MU5066KP50 only).
Name:
If you wish to name the sources, NAME menu provides you with a choice of 52 names (see page 16):
In the event that the optional Digital FM Tuner card is inserted, use the Name selection on the menu to name
FM Tuner presets.
In the event that the optional Audio Port is connected, use the Name selection on the menu to name the source.
IR:
You can adjust the IR Frequency for the global source input for IR Learning. Select 38 kHz or 56 kHz
Can register up to 20 (IR) commands per audio source. Source [S1/S2/S3/S4] with Remote or keypad.
Registered buttons are stored In Main system, and they can be used by other rooms.
Create and set Macros for the keypad:
Eight, 4-step macros (for IR Codes already learned).
The MU5066KP50 also adds the capability for up to 10 macros per global source.
Adjust:
You can adjust the amplifier to match the impedance of the speakers used (8Ω/6Ω/4Ω)
You can adjust the brightness and select color.
Bright: Adjust Brightness level from 0% - 100% 9 steps.
Color: Choose Green or Amber. (KP25S only)
Color: Choose Blue or White. (KP25 and KP50 only)
Timer: On/Off Back Light turns off 3,5,10 or 15 minutes after last button press.
You can adjust the Sleep timer for the room. Select 10, 20, or 60 minutes.
Room:
Control the power (ON/OFF) of all room systems. [R1-R6]
ON: Indicates that a room’s system power is on and can be turned off.
OFF: Indicates that a room’s system power is off and can be turned on.
Turn ALL ROOMS ON or OFF
Select the source for any room on the system by pressing the SRCE button. (Source will begin playing at
the last known volume or the default volume, in the event that the last known volume was less than 15
dB.
EXT (External Audio):
Defines the output direction of audio signal when the Audio Port (EIM) is connected. This menu is
activated either when the Audio Port (EIM) is connected or DFMT is inserted.
ROOM AMP only or
Both ROOM AMP + External AMP (variable output) or
External AMP only (variable output) or
External AMP only (fixed output)
If the keypad has the optional Digital FM Tuner inserted, you can adjust the following:
Tuner Sensitivity: Low / Middle / High
Adjust the spacing for the Tuner Reception: 50 kHz (Europe) / 100 kHz (Europe) / 200 kHz (US, default)
Adjust the Tuner Pre-Emphasis: 50 milliseconds (Europe) / 75 milliseconds (US, default).