SARGENT 8500 Narrow Design Rim Exit Device - Manual (Page 3)

3
5
APPLY HARDWARE
DETERMINE CUT OFF DIMENSION “X" BY
SUBTRACTING 1-1/8" FROM DIMENSION “Y".
MARK CUT OFF POINT ON MOUNTING RAIL.
A
X
Y
VERTICAL REFERENCE
LINE (C OF CHASSIS)
L
FOR DOOR
WITH STILE
RAIL, MUST
OVERLAP
STILE BY 5/16"
1-1/8" MIN.
PUSH
RAIL
3-1/2"
MIN.
CAUTION
DO NOT CUT CLOSER THAN 3-1/2" FROM
THE PIVOT PIN IN THE PUSH RAIL
X
Y
• CHECK BOX LABEL.
IF CUTTING IS NOT REQUIRED,
PROCEED TO STEP “B".
• IF CUTTING IS REQUIRED,
CONTINUE WITH STEP “A".
B
DEPRESS ARM INTO RAIL OPENING AND
SLIDE RAIL ONTO CHASSIS. LEVEL RAIL
AND FASTEN MOUNTING PLATE. B
LEVEL
MOUNTING
PLATE
ATTACH MOUNTING PLATE
TO DOOR WITH
(2) ROUND HEAD SCREWS
TIGHT AGAINST
MOUNTING RAIL
Copyright © 2009-2012, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A6699N