Model 4315 receiver, led indicator operation – SARGENT MPower 4000 User Manual

Page 2

5. Terminate wires as follows:

Red Wire (+) - Terminal 18
Black (-) - Terminal 17
Green (N.O.) - Terminal 9
White (C) - Terminal 8

Note: The Model 4315 Receiver antenna may be
left underneath or inside the 2600 Door Operator.

3. Continue routing the jacketed cable

below the transformer and underneath
the 120VAC terminal block.

4. Bring wires from below the 120VAC

terminal block and around to the main
Control Board.

Programming the Model 4310/4313 Transmitter and Model 4315 Receiver

Enter Learn Mode

Deleting a Transmitter Code from the
Receiver Memory

• Enter Learn Mode by pressing and holding the Mode

Switch button for 3 seconds, the Receiver LED will
flash fast

• Press again the Mode Switch button for 3 seconds.

The Receiver LED will flash 2 times to indicate cleared
memory

Model 4315 Receiver, LED Indicator
Operation

• Steady “ON” - Receiver is receiving an RF signal from

the coded transmitter

• Fast Flash - Learn Mode

• One Flash - Transmitter Code is learned

• Two Flashes - All learned codes are cleared

1. Press and hold the Mode Switch button

for 3 seconds. The Receiver LED will
flash fast.

2. Within 15 seconds of pressing the Mode button,

press the Model 4310/4313 Transmitter button.
The Model 4315 Receiver LED will flash 1 time
when the transmitter code is learned.

4315 Terminal Designation

4310 Shown

permission of Sargent Manufacturing Company is prohibited.

A7446B