Tweco Eliminator Spool Gun User Manual

Page 29

safety and operating instructions

14-25

89200011

SECTION 14:

LINER GUIDE ASSEMBLY REPLACEMENT

1. Remove conductor tube and proceed with removing the conduit liner guide assembly

with a 3/8" wrench and flat screwdriver.

2. Replace liner into guide.

3. Screw liner guide into gun and attach

nut. Do not overtighten nut.

4. Install new assembly into block using

pliers or a 3/8" open end wrench and

screwdriver.

5. If using the white Teflon liner in the front

steel liner guide, the liner should be 1 3/4"

(44,5mm) long and protrude out the rear

of the guide (threaded end) 1/8"- 3/16"

(3,2mm - 4,8mm).

6. The plated steel or copper liner guide

that anchors the conduit between the

gun drive roll and conductor tube should

protrude no more than 1/8" (3,2mm) from

the gun body after assembly.

NOTE

Make sure the white liner is

not forced back against the

gun drive roll.

Liner Guide Assembly Replacement