Tweco Eliminator Spool Gun - Manual (Page 23)

safety and operating instructions
9-19 89200011
SECTION 9:
CONDUCTOR TUBE & LINER REPLACEMENT
Conductor Tubes
Part No. Stock No. Description
PMP64EL-180 1642-1140 180° Rigid Conductor Tube (Standard)
PMP64EL-30 1642-1141 30° Rigid Conductor Tube
PMP64SFLX-360 1642-1142 Knucklehead ™ Flexible Conductor Tube
1. To remove and replace the conductor tube from the MIG gun, unscrew the insulated
conductor tube-retaining nut from the front end of the gun.
2. To remove the liner within the conductor tube, remove the nozzle from the conductor tube.
3. Unscrew the gas diffuser and remove.
4. Pull the liner out of the conductor tube and cut the replacement liner to the same length
as the one removed.
5. Remove any obstructions to the liner that may be present after cutting to length and insert
into the conductor tube.
NOTE
Make sure the liner fits into the front wire guide in the gun body.
6. Reinstall the nozzle.
Conductor Tube & Liner Replacement