Tweco Eliminator Spool Gun - Manual (Page 28)

13-24
safety and operating instructions
89200011
SECTION 13:
JUMP LINER INSTALLATION
When installing a jump liner, the following steps are recommended to install pieces into the
tube:
1. Remove the conductor tube by loosening the conductor screw cap, then loosen gas
diffuser set screw.
2. Remove jump liner from conductor tube.
3. Make sure that both new and old jump
liners are the same length. Feed the end of
the new jump liner into the conductor tube
until it stops. Secure with diffuser set screw.
If unsure if the liner is seated properly in
the diffuser, remove the set screw and liner
should be visible inside the set screw hole.
NOTE
Do not overtighten the set screw
on the jump liner or the bronze
material will collapse under
extreme pressure. The jump liner
should extend 3/16" (4,7mm) past
the rear flat on the conductor tube.
4. Install conductor tube on the front of the
handle and twist locking nut clockwise to
secure. Insure that the liner in the tube is
seated in the front guide on gun before
tightening.
Jump Liner Installation