Tweco Eliminator Spool Gun - Manual (Page 20)

6-16
safety and operating instructions
89200011
SECTION 6:
LOADING THE SPOOL OF WIRE
1. Load a spool of wire by loosening the
outer knob on the spool cover and
removing the cover.
2. Hold the spool of wire above the
opening while exposing 3” (76,2mm)
of wire away from the spool.
3. Straighten the wire to remove the normal cast and begin lowering the spool downward
over the shaft while inserting the straightened wire into the wire guide.
4. When the wire is positioned between
the drive rolls, adjust the drive roll
pressure to engage the wire enough to
begin feeding the wire forward through
the conductor tube. The spool should
be lowered in place while the wire is
feeding into the conductor tube.
5. Replace the cover and tighten the outer knob.
6. Make final adjustments to the drive roll pressure and adjust the spool brake with
the inner knob of the spool cover.
7. Adjust voltage and wire speed to that recommended by the wire manufacturer.
8. The gun is now ready for operation.
Loading the Spool of Wire