Tweco Eliminator Spool Gun - Manual (Page 22)

8-18
safety and operating instructions
89200011
SECTION 8:
CHANGING OR REPLACING DRIVE ROLLS
1. Guns are shipped standard with 3/64” (1,2mm) drive rolls installed. Optional drive rolls
are available for .030” (0,8mm) through 1/16” (1,6mm) wire, see below table.
Optional Drive Rolls
Wire Size Part No. Stock No.
.030” (0,8mm) EPG103-2-0,8 2031-2091
.035” (0,9mm) EPG103-2-0,9 2031-2077
.040” (1,0mm) EPG103-2-1,0 2031-2023
3/64” (1,2mm) EPG103-2-1,2 2031-2003
1/16” (1,6mm) EPG103-2-1,6 2031-2022
2. To change or replace drive roll, loosen the setscrew on the drive roll with the allen wrench
furnished.
3. Remove the drive roll from the motor shaft and reinstall the new drive roll in its place.
NOTE
Make sure that the drive roll is seated against the brass washer before tightening
the set screw.
4. Drive rolls have two u-grooves in each roll and maybe inverted to double the life of one
drive roll.
Changing or Replacing Drive Rolls