Tweco VA 4000S Ultra-Feed - Manual (Page 37)

ULTRAFEED VA 4000S
Manual No. 0-5135 4-11 OPERATION
Making a switch adjustment: Making a switch adjustment: Making a switch adjustment: Making a switch adjustment: Making a switch adjustment:
To make an adjustment to the system DIP switches, remove the 8 sheet metal screws from the control box and
remove the sheet metal cover and door by gently rocking it forward to pull it free from the feeder assembly. Locate the
870309 Motor Control Board on the opposite side of the feeder assembly as shown in Figure 4-8 below. The DIP
switches are locate at the top of the board as shown. Set switch # 5 according to your set up and replace the cover.
1 2 3 4 5
Front
Switch # 5
Art # A-09244
CLOSED
OPEN
Figure 4-10: Arc Signal Overide DIP Switch Location and Settings