Tweco 180 Portable MIG User Manual
Fabricator, 140 operating manual
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1: SAFETY INSTRUCTIONS AND WARNINGS
- 1.01 Arc Welding Hazards
- 1.02 Principal Safety Standards
- 1.03 Symbol Chart
- 1.04 Precautions De Securite En Soudage A L'arc
- 1.05 Dangers relatifs au soudage à l'arc
- 1.06 Principales Normes De Securite
- 1.07 Graphique de Symbole
- SECTION 2: INTRODUCTION
- 2.01 How To Use This Manual
- 2.02 Equipment Identification
- 2.03 Receipt Of Equipment
- 2.04 General
- 2.05 Machine Specifications
- 2.06 Volt - Amp Curves
- 2.07 Duty Cycle
- 2.08 Fabricator 180A MIG Gun
- 2.09 Installing a New Wire Liner
- 2.10 MIG Gun Maintenance
- SECTION 3: INSTALLATION
- 3.01 Location
- 3.02 Safety
- 3.03 Grounding
- 3.04 Electrical Input Requirements
- 3.05 Requirements for Maximum Output
- 3.06 Installation of Shielding Gas (GMAW) Process
- 3.07 Attaching the Gun and Cable Assembly to the Power Source
- 3.08 Polarity Changeover
- 3.09 Installing Wire Spool
- 3.10 Feedrolls
- 3.11 Install Wire into the Feedhead
- 3.12 Install Wire into the Welding Gun
- SECTION 4: OPERATION
- 4.01 General Safety Precautions
- 4.02 Fabricator Controls
- 4.03 Gas Metal Arc Welding (GMAW)
- 4.04 Flux Cored Arc Welding (FCAW)
- 4.05 Shutdown Procedures
- 4.06 Basic Welding Technique
- 4.07 Welding Gun Positions
- 4.08 MIG Welding (GMAW) Variables
- 4.09 Establishing the Arc and Making Weld Beads
- 4.10 Pre-Weld Procedure
- 4.11 Welding Procedure
- 4.12 Reference Tables
- 4.13 Fabricator 140 Welding Setting Selection Guide
- 4.14 Fabricator 180 Welding Setting Selection Guide
- 4.15 Gas Selection for Gas Metal Arc Welding
- SECTION 5: MAINTENANCE & TROUBLESHOOTING
- 5.01 Cleaning of the Unit
- 5.02 Cleaning of the Feed Rolls
- 5.03 Basic Troubleshooting
- 5.04 Solving Problems Beyond the Welding Terminals
- 5.05 Welding Problems
- 5.06 Power Source Problems
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 2: FABRICATOR 180 SYSTEM SCHEMATIC
- APPENDIX 3: FABRICATOR 140 SYSTEM SCHEMATIC
- APPENDIX 4: FEED ROLL KITS
- LIMITED WARRANTY
- WARRANTY SCHEDULE
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION