Tweco 300 S Arcmaster - Manual (Page 27)

ARCMASTER ® 300 S
March 31, 2006 4-3
n o i t p i r c s e D r e t e m a r a P
HOT START
This parameter operates in STICK weld mode and is used to improve
the start characteristics for stick electrodes. e.g. low hydrogen
electrodes. It sets the peak start current on top of the (WELD) current.
A Weld Current (Amperage)- sets the STICK and TIG WELD current.
ARC CONTROL - This parameter provides a suitable short circuit
current in STICK welding to im prove electrode sticking and arc
stability.
LIFT TIG mode of operation. A remote control device may be used for
use during LIFT TIG operation. See section 4.01, section 2 “Remote
Control Socket ”, for complete details of the remote device.
STICK Mode of operation
CONTACTOR
Contactor operation in STICK Mode
REMOTE
Selects in operation Panel board or Remote
Table 3 – Weld Parameter Descriptions
4.03 Weld Parameters for ARCMASTER 300 S
Weld Mode
Weld
Parameter Parameter Range
Factory
Setting
Incremental
Unit STICK LIFT TIG
HOT START 0 to 70A 20A 1A Yes No
WELD CUR 5 to 300A DC 80A 1A Yes Yes
ARC CONTROL 0 to 100% 10% 1% Yes No