Tweco 200 Ultra-Cut(March 2013) - Manual (Page 77)

Manual No. 0-5133 4-5 OPERATION
ULTRA-CUT 200
4.06 TSC-3000 Selecting Recently Used Process
Art # A-09161
HOME
1
TORCH CONSUMABLES
Check that you have
the correct torch
consumables. (1)
2
1a
3
Home screen shows some of the most recently used processes with the last one
used highlighted. Select the highlighted process by pressing the Green arrow or scroll
with up/down arrows to select another recent process then press the green arrow.
CUT MONITOR
Now you are ready to start cutting. Displayed Amps Demand is the output current
setting, not the actual current.
As soon as Start is applied Process Monitor shows output voltage, gas pressures,
status of Start, OK to Move and Gas On signals. Here you can toggle between Plasma
Marking with the selected consumables and cutting.
If you already know the
settings and consumables
you can go directly to
Process Monitor using
CUT MONITOR button.
(1a).
THC / CNC Settings
TORCH CONSUMABLES
Go to THC / CNC Setting to
see recommended Torch
Height Control and CNC
settings; (2)
1
1a
Use SHOW CUTTING
& SHOW MARKING
to toggle between
views of cutting &
marking settings.
Proceed to
Cut Monitor (3)