Tweco 300 Auto-Cut - Manual (Page 131)

Manual 0-4817 Auto-Cut 300 A-11 APPENDIX
Art # A-04747
10.5" / 267 mm
7"
178 mm
12" / 305 mm
19 lb / 8.6 kg
Dimensions (Input Side Shown)
Installation
The Remote Arc Starter must be installed in a suitable location near the torch head. If the Arc Starter is mounted to a
gantry or any other support subject to motion or vibration, the installer must fasten the Arc Starter securely to the
support.
A. Preparation
1. Loosen, but do not remove, the lower screws securing the cover to the Arc Starter. Remove the upper screws
securing the Cover Panel to the Arc Starter.
NOTE
2. Remove the Cover Panel.
Art # A-09625
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire