Tweco PAK 10 User Manual
Plasma cutting system
Table of contents
Document Outline
- Contents
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SPECIFICATIONS
- 1.1. DESCRIPTION OF EQUIPMENT
- 1.2. SPECIFICATIONS
- 1.3. PLASMA CUTTING
- 1.4. THEORY OF OPERATION
- INSTALLATION
- 2.1 UNPACKING
- 2.2 EQUIPMENT ASSEMBLY
- 2.3 EQUIPMENT INSTALLATION
- OPERATION
- 3.1 OPERATING CONTROLS
- 3.2 PRE-OPERATION SET-UP
- 3.3 OPERATION
- 3.4 CUTTING CURRENT AND SPEED SELECTION
- SERVICE
- 4.1 TORCH MAINTENANCE
- 4.2 TORCH LEADS AND LEADS EXTENSION PACKAGES
- 4.3 PAK UNIT MAINTENANCE
- 4.4 GAS PRESSURE REGULATORS
- 4.5 TROUBLE SHOOTING GUIDE
- 4.6 TEST PROCEDURES
- PARTS LISTS
- General Arrangement
- PAK 10 Cutting System
- Equipment Board Assembly
- Control P.C. Board Assembly
- Control Bridge and Main Bridge Assemblies
- Torch Connection Panel Assembly
- Pilot Resistor and Rear Panel Assembly
- Front Panel Assembly
- Base Components Assembly
- Torch Leads, Leads Extension Packages, Torch Guide and Circle Cutting Attachment, Remote Control Assembly
- Series 4B Gas-Cooled Torches
- Gas Pressure Regulators