Tweco PAK 10 User Manual

Page 2

WARNINGS

Read and understand this entire Manual and your employer’s safety practices before installing, oper-
ating, or servicing the equipment.

While the information contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.

Plasma Cutting System PAK 10
Instruction Manual Number 0-0515

Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711

www.thermal-dynamics.com

Reproduction of this work, in whole or in part, without written per-
mission of the publisher is prohibited.

The publisher does not assume and hereby disclaims any liability to
any party for any loss or damage caused by any error or omission in
this Manual, whether such error results from negligence, accident, or
any other cause.

Printed in the United States of America

Publication Date: April 12, 2002

Record the following information for Warranty purposes:

Where Purchased:_________________________________________

Purchase Date:____________________________________________

Power Supply Serial #:_____________________________________

Torch Serial #:_____________________________________________