Connect and power your device, Getting started, Physical connections – Teradek Cube Reference Guide User Manual

Page 5

Version 2

Page | 5

Connect and Power Your Device

Getting started:

1. To power your Cube, connect the included AC adapter (or accessory power cable, sold

separately) to Cube via the 4 pin LEMO

connector marked „6-28 DC Input‟

(b)

. Cube begins to

boot as soon as power is connected. NOTE: The ENC/DEC LED blinks to indicate Cube is

booting. This process takes approximately 1 ½ minutes.

2. Connect your video source to Cube via BNC cable

(e)

(SD/HD-SDI 1xx models, Composite 5xx

models) or HDMI cable (2xx models).

3. Attach the antenna

(a)

(if applicable) via the threaded RP-SMA connector.

4. Use the i

ncluded hot shoe mount and/or ¼” screw

(f)

to mount Cube to your camera, tripod

mount, or other accessory mount, if desired.

Once Cube has booted, verify that the „ENC‟ and „VID‟ LEDs are green, indicating video is

successfully detected

(c)

For more information about Cube‟s physical connections and power options, please see the following

sections.

Physical connections:

Left: Cube 1xx SDI encoder, Right: Cube 2xx HDMI encoder

Left: Cube 3xx SDI decoder, Right: Cube 4xx HDMI decoder