Soleus GPS Tour (SG004) - Manual - Manual (Page 5)

GPS Tour
How to set the NIGHT mode function:
• Press S5 while NIGHT is blinking. The watch will display 10 seconds blinking.
• Press S1/S5 to change to 20 sec or NIGHT ON.
• While on 10 SEC or 20 SEC setting, Press S5 to accept the setting and go back to
NIGHT setting screen.
• While on NIGHT ON setting screen Press S5 to accept the ON setting. The watch will
display the START TIME.
• Press S1/S11 to toggle between START TIME and END TIME.
• Press S5 or 3 seconds auto to set the START TIME. Hour digit will start to blink.
• Press S1/S11 to change the hour setting.
• Press S5 to change the MINUTE. Minute digits will start to blink.
• Press S1/S11 to change the minute setting.
• Press S5 to go back to START TIME setting screen.
• Press S1/S11 to set the END TIME. Hour digit will start to blink.
Note: Follow the procedure in setting the START TIME.
• Press S7 to exit to NIGHT ON setting screen.
Night mode settings:
• 10 SECONDS – Press S11 will turn ON the Light for 10 seconds.
• 20 SECONDS – Press S11 will turn ON the Light for 20 seconds.
• NIGHT ON – Light will continuously ON when CHRONO is running in preset duration time
(5:00 pm to 7:00 am). Start and End time can also be manually set to different times.
How to set the CHIME:
• Press S5while CHIME is blinking. The watch will display CHIME ON.
• Press S1/S11 to change to CHIME OFF or OFF.
• Press S5/S7 to confirm and exit to CHIME setting screen
How to set the ALARM:
•
Press S5 while ALARM is blinking. AL-1 will start to blink.
• Press S1/S1 to toggle through Alarm 1 to alarm 5. The watch has 5 alarms which can be
set individually
• Press S5 to set the selected Alarm. The HOUR digit will start to blink.
• Press S1/S11 to change the hour digit.
• Press S5 to confirm and set the MINUTE digit. The minute digit starts to blink.
• Press S1/S11 to change the minute digit.
• Press S5 to confirm and set the T1 or T2 setting. T1 or T2 starts to blink. The alarm time
will be referred to Time 1 or Time 2.
• Press S1/S11 to change setting
• Press S5 to confirm. Alarm ON or OFF will start to blink.
• Press S1/S11 to change the setting.
• Press S5 to confirm and go back to ALARM 1 setting screen
• Press S7 to exit.