Soleus GPS Tour (SG004) - Manual - Manual (Page 2)

GPS Tour
Step 2) Charging the Battery:
Charge the unit for at least 4 to 5 hours before first use. The length of time for a fully charged
battery will last depending on the actual usage. It is recommended to regularly re-charge your
battery every 1-2 months even if it is not used to maintain good battery condition.
2.1) Plug your USB PC link cable to your PC
2.2) Align the charging clip with the contacts on the back of the Watch.
2.3) Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and prevent corrosion.
When the battery is low, it is time to charge the watch.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The watch will display LOW BATT. You
need to recharge the battery in order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be
saved. Please make sure the battery have enough battery power before doing your exercise
in order not to lose your data.
Step 3) Configure your Watch:
Before using your watch, you may please set your Watch.
3.1) While in TIME mode, press S7 to go to SET mode and set the following parameters:
AUTO LAP, TIME, UNITS, USER, HRM, HRM LINK, VIEW, NIGHT, Contrast, CHIME,
ALARM, TIMER, and SCALE.
Press S1 or S11 to change the blinking parameter to set.
How to set the AUTOLAP:
• Press S5 while AUTO LAP is blinking. Auto lap 1 will start to blink.
• Press S1/S11 to change the setting. Auto lap preset settings are: off, 0.4, 1, 2, 3, 4,
and 5 KM.
• Press S5/S7 to confirm and set ALERT ON or OFF.
• Press S1/S11 to change the setting. There is a beep sound and EL on for 10 sec every
auto lap taking when ALERT is set to ON.
• Press S5/S7 to confirm setting and go back to Auto lap setting screen.