Soleus GPS Tour (SG004) - Manual - Manual (Page 10)

GPS Tour
5.5. If the heart rate data does not appear on the Watch, or if you have erratic data, follow the
tips below. If the problem persists, you may have to pair the HR belt again.
• Make sure the HR belt is snugly fit to your body.
• Reapply water or electrode gel to the electrode of the HR belt.
• Clean the electrodes from possible contamination that may interfere with heart rate
signals.
• Wear a cotton shirt or if possible, wet your cotton shirt. Synthetic fabric that rubs
with your skin may create static electricity and interfere with the heart rate signal.
• Move away from strong electromagnetic fields and other wireless sensors which can
interfere with your heart rate sensor. Possible sources of wireless interference may
include high voltage power lines, electric motors, microwave ovens, cordless
phones, and wireless LAN or access points.
5.6. How to turn ON the HRM function of the watch:
• While HRM is initially OFF, press & hold S5 in any mode to turn ON the HRM
function except when the Chronograph in any mode is STOPPED. In this case, you
will enter the GO BACK function of the watch.
• The watch will display HRM ON and the heart icon will start to blink until the HRM
signal is linked to the watch.
• Your HRM data will now be displayed in the watch.
• When you change the display by pressing S5 in any exercise modes, the watch will
auto turn ON the HRM function.
5.7. How to turn OFF the HRM function of the watch:
• While HRM is initially ON, press & hold S5 in any mode to turn OFF the HRM
function except when the Chronograph in any mode is STOPPED. In this case, you
will enter the GO BACK function of the watch.
• The watch will display HRM OFF and the heart icon will be auto turned OFF also.
• If HRM is OFF, the watch will not be able to receive the HRM signal from the HRM
belt.