GBC Digicoil - Manual (Page 9)

8
21) If the Auto Cycle Mode is used the LCD displays “Cycle Active”. The machine will wait for the Auto
Cycle Delay to complete then automatically start the next machine cycle.
6. If the Operator presses the Cut Crimp Setup button the machine will cycle normally to the point where the book
drops to the chute then ask the operator to check the position of the cutters before finishing the cycle. After the
operator is satisfied with the position of the cutters he will press the foot switch to continue the cycle.
7. If the Operator presses the Auto cycle button the machine will start normally when the operator presses the foot
switch. After the machine finishes the cycle. The machine will wait for the Auto Cycle Delay to complete then
automatically start the next machine cycle. If the operator fails to have the next coil in the Coil Loading Bracket
the machine will reset the Load Clutch Solenoid and wait for the next foot switch operation.
4. FUNCTIONAL PARTS DESCRIPTION