GBC Digicoil User Manual
Page 17
16
Auto Cycle
Pressing the Auto Cycle button activates the Auto Cycle feature on the DigiCoil. By doing this, the operator eliminates the
use of the Foot Switch. The unit automatically runs the complete cycle after a timed delay. The time of the delay is
variable from 0-10 seconds and is set by the operator using the Keypad. If no coil is present when the Detection Arm goes
down, the machine will reset itself to normal operational mode. The operator may resume binding by pressing Start or by
using the Foot Switch, but the Auto Cycle button must be pressed again to re-activate the automatic cycling.
1. Press the Auto Cycle button.
2. Load the coil.
3. Load the document.
4. Press the Foot Switch to start the Auto Cycle.
5. Repeat Steps 2 and 3 until all documents have been bound.
6. Press the Foot Switch to eject the final document.
To change the timed delay of the Auto Cycle Mode:
1. Press Reset.
2. The LCD will read “Ready Press Start”.
3. Press the Up arrow on the Keypad and hold until the LCD shows the current setting of the Auto Cycle Delay in
seconds.
4. Press the Down service arrow to scroll through settings 0 – 10. Stop pressing the Down arrow key when the
desired delay appears on the LCD.
5. Press and hold the Up arrow until the LCD reads “Ready Press Start”.